After copying an SIS plan into SOP, the planning figures for the
material are uniformly distributed over all of the plants. If, however
the planning figures need to be distributed according to proportion for
plant (defined quota), then table 445V must be maintained for the
plant distribution.
Determining plant distribution
===========================
1. If the info structure includes a plant field, no plant distribution
is necessary and cumulation can be carried out directly.
2. If, on the other hand, plant distribution is necessary, table 445V
along with the material number and plant is read in.
3. If such an entry exists the respective plant proportion will be set.
4. If there is no entry, then distribution will be carried out among all
of the plants uniformly, or the plants will be given a proportion
by means of a general plant quota. The variant that is used here is
determined in table 445V. If there is only one entry for the
material number SPACE, with a positive proportion, then it is
understood that distribution over plant proportions should be
performed. If no such entry exists, uniform distribution will be
carried out. The existence of such an entry was already tested
above (FLG_GLEICHVERTEILUNG).
5. If distribution is done via quotas, plants without any entry will
then receive no proportion. Note: In the system, if only 1 plant
exists then the entire value is added to this plant, if there is
either no entry with material number SPACE or if there is a positive
quota for this plant.
6. Table 445V
Maintain the table using transaction SM31. The plant quotas should be
entered as proportions and not as percentages!
Example: There are two plants (1,2). Plant 1 has 30% of the material
proportion, plant 2 70%. The following entries should be
made in table 445V:
Material Plant Proportion
1 0.3
2 0.7
Additional key words
Rough planning, MCSD, MC87
No comments:
Post a Comment